Diy waterfall fountain outdoor how to#

It doesn’t have to look pretty it will not be seen once the fountain is complete. Add bricks or other filler material around the riser to steady it in place. Run the power cord through the notch you created in the riser and out the top of the large planter.

Put the pump in the bottom planter, followed by the riser piece (PVC pipe, upside-down flower pot, upside-down bucket). Once you have scouted out the perfect spot for your water fountain, begin the assembly. The ideal spot has access to a power outlet and your favorite chair. The fountain will start to get heavy and will not be easy to move.

Final LocationĪt this point, it is best to move the large planter to the fountain’s final location. Create a notch in the bottom of the riser to accommodate the pump’s power cord. Drill holes in the sides of the riser so the water will circulate properly inside your fountain. The piece will need to be large enough to enclose the pump at the bottom of the planter. This is where you will use either a length of PVC pipe, plastic flower pot, or a bucket. The riser creates an elevated surface on which the saucer and upper planter will rest. Riser Choiceįor the next step, you will need to decide which riser option is best for your application. If you have enough filler material (bricks, concrete pieces, decorative rocks) the saucer can be omitted. The saucer creates a false bottom that will be covered with decorative rocks to hide the mechanics of the pump and riser below. This hole should be large enough to accommodate the pump extension tube that feeds the fountain. While the silicone is setting, drill a hole in the center of the plastic saucer. This should be completely set before adding water to the fountain. After an hour or so, turn the large planter over and seal the underside as well. Otherwise, fill the hole with caulk as in our example. If the hole is large, use a rubber drain plug and then seal with silicone caulk. Because the lower planter is acting as the reservoir, you need to plug any holes in the large planter. This means there is no need to dig a hole in the ground and bury a reservoir. This DIY water fountain is self-contained. If it doesn’t, you will need to purchase an additional length of tubing.

Be sure your pump has an extension tube long enough to reach the top of the upper pot.

You can find this information in the specs of the pump.

The water pump must have enough vertical lift to pump the water from the bottom planter through the upper pot and out the nozzle.

The bucket needs to be tall enough to elevate the top planter appropriately.

Another riser option is an upside-down bucket.

An inexpensive plastic flower pot turned upside down is an alternative to the PVC pipe riser.

A piece of PVC pipe cut to length works well as a riser for this part of the project.

The drill bit needs to be large enough to allow the pump extension tube to comfortably fit through without being too tight.

This saucer should be slightly smaller than the top of the bottom planter.

You can use a rubber drain plug to fill the bulk of the hole and then seal around it with caulk.

Caulk will be used to seal the holes in the bottom of the large pot.

The planters will need to be sturdy enough to hold the weight of the water, decorative rock, and pump.

You can get these in a variety of shapes and colors which instantly adds interest to your patio. For this project, we suggest using two different-sized glazed terra cotta or ceramic garden pots.

You can make a water fountain out of almost anything. A patio water fountain emits the same soft sounds of flowing, trickling, bubbling water as any large body of H2O.

The good news is you don’t have to live on the coast to receive the health benefits of water on your health. The best part is you don’t have to DO anything to receive the benefits. The benefits of living around water are well documented and range from boosting mood to improved immune systems. The addition of a water feature in your landscaping adds interest and can have a positive effect on your overall wellness.

Diy waterfall fountain outdoor how to#

In this article, we will explain how to build a DIY water fountain. You are only limited by your imagination, and perhaps your wallet. There are a plethora of options when it comes to a garden water feature.